RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Marker Lamp: Service and Repair
Marker Lamp Replacement
Marker Lamp Replacement
REMOVAL
Individual lamps may be replaced by removing the lamp from the light bar. Using a flat blade screwdriver, carefully pry lamp to disengage clips
attaching ID lamp to retainer.
1. Disconnect and isolate the battery negative cable.
Rear Identification Lamps
2. Remove four screws attaching rear ID lamps to tailgate.
3. Separate ID lamps from tailgate.
4. Disengage ID lamp wire connector from body wire harness.
5. Separate ID lamp from vehicle.
INSTALLATION
1. Position ID lamp ON vehicle.
2. Engage ID lamp wire connector to body wire harness.
3. Install screws attaching rear ID lamps to tailgate.
4. Connect the battery negative cable.
