RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Turn Signal Flasher: Service and Repair
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND
ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM
CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE
WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the fuse access panel by unsnapping it from the left outboard end of the instrument panel.
Fig. 7 Junction Block
3. Remove the combination flasher from the Junction Block (JB).
INSTALLATION
1. Position the combination flasher in the proper receptacle of the Junction Block (JB).
2. Align the terminals of the combination flasher with the terminal cavities in the JB receptacle for the flasher.
3. Push in firmly and evenly on the combination flasher until the terminals are fully seated in the terminal cavities of the JB receptacle for the flasher.
4. Reinstall the fuse access panel by snapping it onto the left outboard end of the instrument panel.
5. Reconnect the battery negative cable.
