RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Information Bus: Component Tests and General Diagnostics
The CCD data bus can be monitored using the DRBIII scan tool. However, it is possible for the data bus to pass all tests since the voltage parameters
will be in "range" and false signals are being sent. There are essentially 12 "hard failures" that can occur with the CCD data bus:
*
Bus Shorted to Battery
*
Bus Shorted to 5 Volts
*
Bus Shorted to Ground
*
Bus (+) Shorted to Bus (-)
*
Bus (-) and Bus (+) Open
*
Bus (+) Open
*
Bus (-) Open
*
No Bus Bias
*
Bus Bias Level Too High
*
Bus Bias Level Too Low
*
No Bus Termination
*
Not Receiving Bus Messages Correctly
Refer to the appropriate diagnostic information for details on how to diagnose these faults using a DRB III scan tool.
Refer to the Body Control System See: Body Control Modulefor further Diagnostics of these systems.
*
Airbag Control Module
*
Radio
*
Amplifier (if equipped)
*
Transmission Control Module
*
Compass Mini-Trip Computer (if equipped)
*
Electro/Mechanical Instrument Cluster
Bus Failure Visual Symptom Diagnosis
The following visible symptoms or customer complaints, alone or in combination, may indicate a CCD data bus failure:
*
Airbag Indicator and Malfunction Indicator Lamp (MIL) Illuminated
*
Instrument Cluster Gauges (All) Inoperative
*
No Compass/Mini-Trip Computer (CMTC) Operation (if equipped).
