RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
15. Install air tube (intake manifold-to-charge air cooler) (Fig. 49). Tighten clamps to 8 Nm (72 in. lbs.) torque.
16. Install engine oil dipstick tube support mounting bolt and tighten to 24 Nm (18 ft. lbs.) torque.
17. Install engine oil dipstick to engine.
18. Connect 2 electrical cables to cable mounting studs.
19. Connect electrical connector to bottom of APPS by pushing connector upward until it snaps into position.
20. Connect wiring harness (clip) at bottom of Accelerator Pedal Position Sensor (APPS) mounting bracket (Fig. 48).
21. Connect front wiring clip (Fig. 49) to cable bracket housing.
22. Install cable cover (Fig. 47).
23. Connect both negative battery cables to both batteries.
24. Bleed air from fuel system. Do this at fuel injector ends of lines. Use cylinders numbers 1, 3 and 4 for bleeding. After bleeding tighten fittings to
38 Nm (28 ft. lbs.) torque
25. Check lines/fittings for leaks.
