RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Throttle Cable/Linkage: Service and Repair
REMOVAL
1. Disconnect both negative battery cables at both batteries.
Fig.39 Cable Removal/Installation At Pedal
2. From inside vehicle, hold up accelerator pedal. Remove plastic cable retainer and throttle cable core wire from upper end of pedal arm (Fig. 39).
The plastic cable retainer snaps into pedal arm.
3. Remove cable core wire at pedal arm.
4. From inside vehicle, pinch both sides of plastic cable housing retainer tabs at dash panel.
5. Remove cable housing from dash panel and pull cable into engine compartment.