RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Fig. 11 Driver Airbag Trim Cover Retainer Nuts Remove/Install
3. Remove the plastic wire retainer that captures the horn switch feed pigtail wire between the upper left inflator stud and the inflator on the back of
the driver airbag housing.
4. Remove the four nuts that secure the upper and lower trim cover retainers to the studs on the back of the driver airbag housing
Fig. 12 Driver Airbag Trim Cover Retainers
5. Remove the upper and lower trim cover retainers from the airbag housing studs.
6. Remove the horn switch ground pigtail wire eyelet terminal from the upper right airbag housing stud.
