RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Fig. 14 Driver Airbag Trim Cover Locking Blocks Engaged
2. Engage the upper and lower trim cover locking blocks with the lip of the driver airbag housing, then engage the locking blocks on each side of the
trim cover with the lip of the housing. Be certain that each of the locking blocks is fully engaged on the lip of the airbag housing.
3. Reinstall the horn switch ground pigtail wire eyelet terminal over the left upper airbag housing stud.
4. Reinstall the upper and lower airbag trim cover retainers over the airbag housing studs. Be certain that the tabs on the retainers are engaged in the
retainer slots of the trim cover locking blocks.
5. Install and tighten the nuts that secure the trim cover retainers to the airbag housing studs. Tighten the nuts to 10 Nm (90 in. lbs.).
6. Route the horn switch feed pigtail wire between the inflator housing and the right upper airbag housing stud.
7. Reinstall the plastic wire retainer onto the right upper airbag housing stud to capture horn switch feed pigtail wire.
8. Reinstall the driver airbag onto the steering wheel. (Refer to RESTRAINTS/ DRIVER AIRBAG - INSTALLATION). See: Removal and
Installation
