RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Clutch Linkage: Service and Repair
LINKAGE / REMOVAL
NOTE: The factory installed hydraulic linkage has a quick disconnect at the slave cylinder. This fitting should not be disconnected, the hydraulic
linkage is serviced as an assembly only, but it comes as two pieces to ease installation. Once the clutch hydraulic line is connected to the slave
cylinder, it should not be disconnected. "Chrysler does not provide a procedure to bleed the clutch hydraulic system".
1. Raise and support vehicle.
2. Remove nuts attaching slave cylinder to studs on clutch housing (Fig. 25).
3. Remove slave cylinder from clutch housing.
4. Remove the plastic clip securing the hydraulic line to the dash panel from the lower dash panel flange.
5. Remove the plastic clip securing the hydraulic line to the dash panel from the upper dash panel stud.
6. Lower vehicle.
7. Disconnect clutch pedal interlock switch wires.
