RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
10. Install yoke with Installer C-3718 and Yoke Holder 6719A (Fig. 59).
11. Install yoke washer and a new nut on the pinion gear. Tighten the nut to 291 Nm (215 ft. lbs.) minimum. Do not over-tighten. Maximum torque is
678 Nm (500 ft. lbs.).
CAUTION: Never loosen pinion gear nut to decrease pinion preload torque and never exceed specified preload torque. If preload torque is exceeded a
new collapsible spacer must be installed.
12. Use Yoke Holder 6719A to hold the yoke (Fig. 60) and tighten the nut in 6.8 Nm (5 ft. lbs.) until the rotating torque is achieved. Measure the
preload torque frequently to avoid over-tightening the nut.