RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Seals and Gaskets: Service and Repair
NV241HD - Transfer Case
Extension Housing Bushing and Seal
NV241HD - Transfer Case
EXTENSION HOUSING BUSHING AND SEAL
REMOVAL
1. Raise and support vehicle.
2. Remove rear propeller shaft.
3. Using a suitable pry tool or slide-hammer mounted screw, remove the extension housing seal.
4. Using Remover 8155, remove bushing from extension housing (Fig. 97).
INSTALLATION
1. Clean fluid residue from sealing surface and inspect for defects.
2. Position replacement bushing in extension housing with fluid port in bushing aligned with slot in housing.
3. Using Installer 8156, drive bushing into housing until installer seats against case (Fig. 98).