RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Power Window Switch: Testing and Inspection
The auto down feature of the driver side power window switch is controlled by an electronic circuit within the switch unit. The auto down circuitry is
activated when the driver side power window switch is moved to the second detent in the Down direction. The outputs from the auto down circuitry are
carried through the same switch pins that provide the normal down function. The auto down circuit cannot be tested. If the driver side power window
switch continuity tests are passed, but the auto down feature is inoperative, replace the faulty driver side power window switch unit.
The Light-Emitting Diode (LED) illumination lamps for all of the power window and lock switch and bezel unit switch paddles receive battery current
through the power window circuit breaker in the junction block. If all of the LEDs are inoperative in either or both power window and lock switch and
bezel units and the power windows are inoperative, perform the diagnosis for Power Window System in this group. If the power windows operate, but
any or all of the LEDs are inoperative, the power window and lock switch and bezel unit with the inoperative LED(s) is faulty and must be replaced. For
circuit descriptions and diagrams, refer to the appropriate wiring information. The wiring information includes wiring diagrams, proper wire and
connector repair procedures, details of wire harness routing and retention, connector pin-out information and location views for the various wire harness
connectors, splices and grounds.
1. Check the circuit breaker in the junction block.
If OK, go to Step 2.
If not OK, replace the faulty circuit breaker.
2. Turn the ignition switch to the ON position. Check for battery voltage at the circuit breaker in the junction block.
If OK, turn the ignition switch to the OFF position and go to Step 3
If not OK, repair the circuit to the ignition switch as required.
3. Disconnect and isolate the battery negative cable. Remove the power window and lock switch and bezel unit from the door trim panel. Unplug the
wire harness connector from the switch and bezel unit.
Power Window Switch Continuity - Driver Side