RAM 3500 Truck 4WD L6-6.7L DSL Turbo (2008)
5. Open the hinge cover flap (1) and remove the wire harness (5 - if equipped).
6. Remove the cover (3) from the hinge (4).
INERTIA HINGE
NOTE: Do not reuse the seat fasteners, always replace with new ones.
1. Remove the seat back See: Center Armrest / Seat Back/Removal .
2. Remove the seat back inertia hinge cover See: Center Seat Back Inertia Hinge Cover/Removal .
3. Remove and discard the inertia hinge bolts (1) and remove the hinge (3).
Installation
INSTALLATION
FREE PIVOT HINGE/COVER
