RAM 3500 Truck 4WD L6-6.7L DSL Turbo (2008)
2. Install the mounting bolt for the brake hose (1) at the axle.
3. Install the two brake lines (3) at the bottom of the hose located at the axle.
4. Install the vent hose (2).
5. Install the brake hose clip (2) at the top of the hose (1) located at the frame.
6. Install the brake line (3) to the hose at the frame.
7. Lower the vehicle and remove the support.
8. Bleed the brake system See: Brake Bleeding .
Rear Brake Hose - Heavy Duty (HD)
REAR BRAKE HOSE - HEAVY DUTY (HD)
1. Install the hose (3).
2. Install the banjo bolt (2) at the caliper and tighten fitting bolt to 27 Nm (245 in. lbs.).
3. Install the mounting bolt (4) for the brake hose (3) at the axle.
4. Install the brake line (2) located at the axle.
5. Lower the vehicle and remove the support.
6. Bleed the brake system See: Brake Bleeding .
Removal
REMOVAL