RAM 3500 Truck 4WD L6-6.7L DSL Turbo (2008)
4.
Using one of the self-drilling screws provided and an air ratchet, install the screw located on the dash shield tab (Figure 3).
5.
Using a cotter pin puller (Snap-on SGA173B or equivalent) pierce a hole through the dash silencer pad. Then use a circular motion to enlarge the
hole in the dash silencer pad. Use the dash shield as a template (Figure 4).
CAUTION:
Failure to pierce a hole through the dash silencer pad will cause the dash silencer pad material to wrap around the screw during installation.