RAM 3500 Truck 4WD L6-6.7L DSL Turbo (2008)
Manifold Pressure/Vacuum Sensor: Service and Repair
Installation
Installation-Cab/Chassis Models
INSTALLATION-CAB/CHASSIS MODELS
1. Check condition of sensor O-ring.
2. Clean sensor mounting area at intake manifold.
3. Lubricate sensor O-ring and sensor mounting hole in intake manifold cover with clean engine oil.
4. Position sensor (4) into intake manifold.
5. Install and tighten sensor mounting screw (5) to 1 Nm (9 in. lbs.) torque.
6. Connect electrical connector (3) to sensor.
Installation-Pick Up Models
INSTALLATION-PICK UP MODELS
The combination, dual function Intake Manifold Air Temperature Sensor/MAP (IAT/MAP) (3) sensor is installed into the intake air connection
manifold, below, and to the rear of the EGR valve (5).
1. Check condition of sensor O-ring.
2. Clean sensor mounting area at intake manifold.
3. Lubricate sensor O-ring and sensor mounting hole in intake manifold with clean engine oil.
