RAM 3500 Truck 4WD L6-6.7L DSL Turbo (2008)
Power Distribution Module: Customer Interest
Computers/Controls - CCN Update For Recall J35
NUMBER: 18-016-10
GROUP: Vehicle Performance
DATE: April 30, 2010
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 18-013-08 REV. A, DATED DECEMBER 4, 2008, WHICH SHOULD BE
REMOVED FROM YOUR FILES. THIS IS A COMPLETE REVISION AND NO ASTERISKS HAVE BEEN INCLUDED.
Either wiTECH, StarMOBILE DESKTOP CLIENT -OR- StarMOBILE STANDALONE MODE or StarSCAN(R) can be used to perform this bulletin.
FLASH FILES FOR THIS BULLETIN ARE AVAILABLE VIA THE INTERNET.
WiTECH(R) SOFTWARE LEVEL MUST BE AT RELEASE 10.03 OR HIGHER. StarSCAN(R) SOFTWARE LEVEL MUST BE AT RELEASE 9.05
OR HIGHER.
SUBJECT:
FLASH: CCN Update Required With J35 Recall
OVERVIEW:
This bulletin involves:
-
As stated in Recall J35, verify that Emission Recall G30 - Replace Oxygen Sensor Module and Reprogram ECM has been performed. If not, perform
Recall G30 first.
-
Verifying software level, and if necessary, selectively erasing and reprogramming the Cab Compartment Node (CCN) module with new software.
-
It is recommended to discuss with the customer any required necessary maintenance as suggested in the owners manual. Inform the customer the
importance of properly maintaining their vehicle. Possible required maintenance items may include (not limited to) lube, oil change and filter service,
air filter replacement, fuel filter replacement, and crankcase ventilation filter replacement and EGR valve cleaning based on customer use and
mileage accumulation.
CUSTOMER INFORMATION SHEET INCLUDED:
Please print the "DIESEL EXHAUST AFTERTREATMENT SYSTEM" at the end of this bulletin for customer reference.
MODELS:
2007 - 2008
(DH)
Ram Pick Up Truck (2500 Series)
2007 - 2008
(D1)
Ram Pick Up Truck (3500 Series)
NOTE:
This bulletin applies to vehicles equipped with a Cummins 6.7L engine (sale code ETJ).
NOTE:
2009 MY vehicle had proper CCN software installed during production.
SYMPTOM/CONDITION:
NOTE:
Many improvements have been addressed with the latest Engine Control Module (ECM) software addressed in Recall J35. The Cab Compartment
Node (CCN) may require updating in conjunction with the Recall. This Service Bulletin (SB) only addresses the labor associated with the
reprogramming of the CCN. Any other labor associated with the performance of additional diagnostics is not addressed by this SB and must be
claimed separately.
DIAGNOSIS:
If J35 Recall is being performed, verify the CCN is up to date with the latest software (flash) and that Recall G30 Has been performed. Using a Scan
Tool (StarSCAN(R) / StarMOBILE(R)) with the appropriate Diagnostic Procedures available in TechCONNECT(R), verify all engine systems are
functioning as designed. If DTC's other than those listed above are present record them on the repair order and repair as necessary before proceeding
further with this bulletin.
1. Is the vehicle eligible to have Emissions Recall G30 - Replace Oxygen Sensor Module and Reprogram ECM performed?
