RAM 3500 Truck 4WD L6-6.7L DSL Turbo (2008)
CAUTION: When installing puller 8677 to separate the ball joint, be careful not to damage the ball joint seal.
7. Remove the lower ball joint nut. Separate the ball joint from the knuckle with Remover 8677 (2).
8. Remove the steering knuckle (1) from the vehicle.
9. Remove the hub/bearing from the steering knuckle on the bench See: Suspension/Wheel Bearing/Service and Repair/Front Hub / Bearing -
Removal .
2500 & 3500 - 4WD - Link/Coil
2500 & 3500 - 4WD
1. Remove the hub bearing See: Suspension/Wheel Bearing/Service and Repair/Front Hub / Bearing - Removal .
2. Remove tie-rod or drag link end from the steering knuckle arm.
3. Remove the wheel speed sensor. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed Sensor/Service and
Repair/Front Wheel Speed Sensor - Removal .
4. Loosen the upper ball stud nut.Do not remove the nut at this time.
5. Remove the lower ball joint nut.
