RAM 3500 Truck 4WD L6-6.7L DSL Turbo (2008)
6. Install the brake caliper adapter with the caliper, See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/Removal
and Replacement/Disc Brake Caliper Adapter - Installation .
7. Install the hub extension and nuts to the front rotor. Tighten nuts to 130 Nm (96 ft.lbs). HD DRW ONLY.
8. Install the wheel and tire assemblies, See: Service and Repair/Removal and Replacement .
9. Remove the support and lower the vehicle.
10. Apply the brakes several times to seat the brake shoes and caliper piston. Do not move the vehicle until a firm brake pedal is obtained.
4500 & 5500 - Link/Coil
4500 & 5500
NOTE: If installing a NEW hub/bearing on a 4X4 only Steps 1-3 should be followed for the correct shim size.
1. Measure from the new hub/bearing unit crimp (2) to the flange (3).
2. Choose the correct shim according to the table:
3. Check the shim (2) on the axle shaft (3). Be sure that the shim (2) is placed with the radius side (1) to the joint.
4. Install the hub/bearing to the knuckle. Tighten the hub/bearing bolts (1) to 202 Nm (149 ft. lbs.
