RAM 3500 Truck 4WD L6-6.7L DSL Turbo (2008)
4. Loosen bolts holding rear of pan to transmission.
5. Slowly separate front of pan and reusable gasket (2) away from transmission allowing the fluid to drain into drain pan.
6. Hold up pan and remove remaining bolt holding pan to transmission.
7. While holding pan level, lower pan and gasket away from transmission.
8. Pour remaining fluid in pan into drain pan.
9. Remove screws holding filter (2) to valve body.
10. Separate filter from valve body and pour fluid in filter into drain pan.
11. Dispose of used trans fluid and filter properly.
INSTALLATION
1. Position a new transmission oil filter (2) onto the valve body.
2. Install the screws to hold the filter to the valve body. Tighten the screws to 4 Nm (35 in.lbs.).
3. Clean the gasket surfaces of the transmission oil pan (3) and transmission pan rail.
NOTE: The transmission pan oil gasket (2) is reusable. Inspect the sealing surfaces of the gasket. If the sealing ribs on both surfaces
