RAM 3500 Truck 4WD L6-6.7L DSL Turbo (2008)
14. Remove fill plug (1), from right side of carrier.
15. With axle level, fill carrier with lubricant to the bottom of the fill plug hole.
16. Install fill plug (1) and tighten to 68 Nm (50 ft. lbs.).
WHEEL HUB OIL FILL
CAUTION: Wheel hub cavities must be filled with lubricate before using axle. Failure to follow these instruction will result in hub bearing
damage.
1. Raise right end (1) of axle six inches. Hold in this position for one minute to fill left hub (2) with lubricate.
2. Lower the axle.
3. Raise left end (1) of axle six inches. Hold in this position for one minute to fill right hub (2) with lubricate.
4. Lower the axle.
