RAM 3500 Truck 4WD L6-6.7L DSL Turbo (2008)
5. Using a suitable pry tool (2), remove the slinger (1) from the output shaft using care not to damage the shaft.
6. Using a screw and a slide hammer, remove the front output shaft seal.
Installation
INSTALLATION
1. Install the new front output shaft seal with Seal Installer MB991168A.
2. Install the front output shaft seal slinger with Oil Slinger Installer 8840. Install the slinger onto the shaft until the tool contacts the rear of the
output shaft.
3. Install a new seal boot clamp onto the seal boot.
4. Install the seal boot (1) and clamp onto the slinger hub and tighten the clamp with Axle Clamp Installer C-4975A.
5. Install front propeller shaft See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and Replacement .
Removal
REMOVAL
