RAM 3500 Truck 4WD L6-6.7L DSL Turbo (2008)
1. Raise and support vehicle.
2. Remove rear propeller shaft. See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement
3. Use a suitable chisel or pry tool to remove the rear extension housing dust boot (2).
4. Use a suitable chisel or pry tool to remove the rear extension housing seal.
Installation
INSTALLATION
1. Clean fluid residue from sealing surface and inspect for defects.
2. Install the extension housing dust boot and seal assembly with Seal Installer 9037 (3) and Universal Handle C-4171 (2).
3. Install propeller shaft. See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and Replacement
4. Verify proper transfer case fluid level.
5. Lower vehicle.
Removal
REMOVAL