RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
the door trim panel directly off of the door or damage to the trim panel and/or the power switch assembly will occur.
6. Lift the door trim panel straight upward to disconnect the molded plastic retaining clips (5) from the door.
7. If equipped, disconnect the door wire harness from the power door switch assembly and remove the door trim panel.
Installation
INSTALLATION
1. If equipped, connect the door wire harness to the power door switch assembly.
CAUTION: The door trim panel is attached to the door by molded plastic retaining clips that are integral to the door trim panel. Do not force
the door trim panel onto the door or damage to the trim panel and/or the power switch assembly will occur.
2. Position the door trim panel (3) and align the molded plastic retaining clips (5) to the door.
3. Push the door trim panel straight downward until all of the retaining clips are fully engaged to the door.
4. Install the two screws (2) that secure the door trim panel to the two screw inserts (1).
5. Install the two screws (4) that secure the door trim panel to the bottom of the door.
6. If equipped, install the manual window crank.
7. Position the interior door handle (2) onto the interior door handle actuator (3).
8. Install the screw (1) that secures the interior door handle to the interior door handle actuator. Tighten the screw securely.
