RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
4. Install a new pivot bolt (1) and tighten to 25 Nm (18 ft. lbs.).
5. Install the center seat back.
INERTIA HINGE
NOTE: Do not reuse the seat fasteners, always replace with new ones.
1. Install the inertia hinge (3) onto the center seat back (2) and install new bolts (1).
2. Tighten the bolts (1) to 25 Nm (18 ft. lbs.).
3. Install the seat back inertia hinge covers.
4. Install the center seat back.
Removal
REMOVAL
1. Open the center armrest/seat back.
2. Remove the four screws attaching the hinge to the storage bin/cushion and remove the lid.
Installation
INSTALLATION
1. Position the center seat back lid onto the storage bin/cushion and install the screws.
Removal
