RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
2. Tighten the bolts (2) to 12 Nm (9 ft. lbs.).
3. Install the seat.
Removal
REMOVAL
1. Fold both rear seats flat.
2. Remove the filler panels from the rear seat to storage compartment.
3. Separate the J-straps at the bottom of the seat back.
4. Remove both hinge covers from the back section being worked on.
5. Remove the lower anchor for the center seat belt.
6. Disconnect the lower cable attachment from the seat back release.
7. Remove the four bolts and remove the seat back from the seat.
8. Mark the location of the cables at the cushion and remove.
9. Remove the upper cushion pivot bolts.
10. Remove the lower cushion pivot bolts.
11. Remove the cushion from the seat.
12. Remove the seat release/recline handle.
13. Separate the J-straps for the cover to the seat pan.
14. Remove the cover/cushion from the seat pan and separate the foam from the cover.
Installation
INSTALLATION
1. Place cover over the foam and install onto the seat pan.
2. Connect the J-straps to the pan.
3. Install the release/recliner handle.
4. Install the cushion assembly onto the seat assembly.
5. Install the lower cushion pivot bolts.
6. Install the upper cushion pivot bolts.
7. Install the cables at the cushion using the marks made during removal.
8. Install the seat back onto the seat and install the four bolts.
9. Connect the lower cable attachment for the seat back release.
10. Install the lower anchor for the center seat belt.
11. Install the hinge covers.
12. Connect the J-straps at the bottom of the seat back being worked on.
13. Install the filler panels.
