RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
7. Remove the prop rod.
8. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be
performed..
9. Install the tire and wheel assembly.
10. Lower the vehicle.
Rear
REAR
1. Install caliper (6) to the caliper adapter (1).
2. Coat the caliper mounting slide pin bolts (3) with silicone grease. Then install and tighten the bolts to 30 Nm (22 ft. lbs.).
3. Install the brake hose banjo bolt if removed.
4. Install the brake hose (4) to the caliper (6) with new seal washers and tighten fitting bolt to 27 Nm (245 in. lbs.).
CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.
5. Remove the prop rod from the brake pedal.
6. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be
performed..
7. Install the wheel and tire assemblies.
8. Remove the supports and lower the vehicle.
9. Verify a firm pedal before moving the vehicle.
Front
FRONT
1. Raise and support the vehicle.
2. Remove the front wheel and tire assembly.
3. Remove the caliper slide pin bolts (4).
