RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
1. Remove cylinder head cover.
2. Disconnect injector harness connectors (3) at cylinder head cover gasket.
3. Remove injector solenoid nuts (1) at injectors.
4. Remove cylinder head cover gasket (2).
Rocker Housing
ROCKER HOUSING
1. Inspect rocker housing gasket for cuts, nicks, or tears. Replace if damaged or if gasket has come out of groove.
2. Inspect rocker housing gasket for proper installation in groove. Gasket bead must be centered in groove. A gasket bead that is tilted to the side will
cause an oil leak.
CAUTION: When installing rocker housing onto cylinder head, do not slide housing from side to side, The gasket could fall out or be
damaged.
3. Install the rocker housing. Carefully guide the rocker housing evenly down onto the cylinder head.
4. Install rocker housing bolts and tighten finger tight.
5. Torque bolts, working from center out, to 24 Nm (18 ft. lbs.).
Cylinder Head Cover
CYLINDER HEAD COVER
