RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
vehicles have a unique, fixed position, black, keyed, lower anchor buckle for the three-point center seat belt lower anchor located on the right side of the
front center seat section. Quad cab and mega cab vehicles have a fixed position front center seat lap belt located on the right side of the front center seat
section. The following procedure applies to the front center seating position belt buckle, the lap belt or the anchor buckle. The three-point front center
seat belt and retractor unit is only used on standard cab vehicles.
1. From the front of the front seat, position the front center seat belt buckle, lap belt or anchor buckle unit (1) through the elastic strap (2) on the side
of the center seat cushion (6).
2. From the front of the front seat, reach between the side of the center seat cushion and the adjacent right or left front outboard seat cushion to route
the lower anchor of the seat belt buckle, lap belt or anchor buckle unit down between the side of the center seat cushion and the adjacent right or
left front outboard seat cushion. Be certain that the belt webbing is not twisted.
3. From behind the front seat, position the lower anchor of the seat belt buckle, lap belt or anchor buckle to the center seat support bracket (3). Be
certain to engage the anti-rotation tab on the lower anchor into the corresponding hole in the center seat support bracket.
4. Install and tighten the screw (5) that secures the lower anchor of the seat belt buckle, lap belt or anchor buckle to the center seat support bracket.
Tighten the screw to 40 Nm (29 ft. lbs.).
5. On standard cab vehicles only, reinstall the stowage tray onto the rear floor panel behind the seat.
