RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
10. Remove the lower trim (3) from the inside of the B-pillar.
11. Disconnect the yellow body wire harness connector (5) from the seat belt tensioner initiator on the retractor (7).
12. On the driver side only, disconnect the white body wire harness connector from the connector receptacle for the seat belt tension reducer located
near the bottom of the retractor.
13. Disengage the two clips that secure the belt web guide (1) to the B-pillar.
14. Remove the screw (4) that secures the upper retractor bracket to the B-pillar.
15. Remove the screw (6) that secures the lower retractor bracket to the B-pillar.
16. Disengage the locating tab on the upper retractor bracket from the hole in the inner B-pillar.
17. Remove the front outboard seat belt and retractor from the B-pillar as a unit.
Rear Center - Mega Cab
REAR CENTER - MEGA CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: All seat belt retractors except the driver side front retractor include a switchable automatic locking mechanism.
1. Fold the 60 percent section of the rear seat back (2) down onto the seat cushion in the cargo storage position, then lift and prop open the seat back
