RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
9. Route the center seat belt lower anchor between the seat back (1) and the seat cushion (2) and position it to the anchor bracket (3). Be certain the
belt webbing is not twisted between the retractor and the anchor bracket.
10. Install and tighten the screw (7) that secures the seat belt lower anchor to the anchor bracket. Tighten the screw to 40 Nm (30 ft. lbs.).
11. Restore the 60 percent seat back filler panel and the seat back to their previous positions.
Rear Center - Quad Cab
REAR CENTER - QUAD CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: The rear center seat belt and retractor is secured to a mounting bracket that includes the right outboard occupant seat belt buckle. The rear right
outboard occupant buckle is available for service only as a unit with the center seat belt and retractor.
NOTE: All seat belt retractors except the driver side front retractor include a switchable automatic locking mechanism.
1. Position the rear center seat belt retractor and right outboard occupant buckle unit (6) onto the rear floor panel near the base of the cab back panel
(1).
