RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Seat Belt Height Adjuster: Service and Repair
Removal
Front
FRONT
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Unsnap the trim cover from the front seat belt turning loop and discard.
2. Remove the screw that secures the seat belt turning loop to the height adjuster (2) on the inside of the upper B-pillar (1).
3. Remove the seat belt turning loop from the height adjuster.
4. Remove the upper trim from the inside of the B-pillar.
5. Loosen the two screws (3) that secure the height adjuster far enough to remove the adjuster from the upper B-pillar.
6. Disengage the tab near the lower end of the height adjuster from the slot in the sheet metal and remove the adjuster from the inside of the B-pillar.
Rear - Mega Cab
REAR - MEGA CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.