RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Shifter A/T: Service and Repair
Installation
INSTALLATION
1. Install the lever assembly (3) reversing the way it came out using care to install the pin (2) in the blocker to slider slot (1).
2. The block inhibitor pin and spring (1) should seat into the slider slot (2).
3. Install the mounting screws (1) and tighten to 12 Nm (105 in. lbs.).
4. Cycle the key from ACC to RUN and ensure that the blocker does not stick or bind.
5. Turn the key to the OFF position and ensure that the shifter will not pull from the PARK position.
6. Connect the over drive switch harness (if equipped) (3).
