RAM 3500 Truck 4WD V10-8.0L VIN W (1997)
RWAL Valve/Combination Valve
8. Remove bolt attaching RWAL valve to combination valve bracket. Then separate RWAL valve from bracket.
INSTALLATION
1. Install RWAL valve on combination valve bracket. Do not tighten RWAL valve bolt completely at this time.
2. Install short brake line that connects RWAL valve to combination valve. Tighten line fittings to 16-23 Nm (9-17 ft. lbs.).
3. Tighten RWAL valve attaching bolt to 23-34 Nm (17-25 ft. lbs.).
4. Install master cylinder on booster mounting studs.
5. Attach antilock harness ground wire to combination valve bracket.
6. Install combination valve bracket on booster mounting studs and against master cylinder.
7. Loosely install nuts that retain master cylinder and combination valve on booster studs.
8. Install and connect all remaining brake lines. Tighten line fittings to 16-23 Nm (9-17 ft. lbs.).
9. Connect harness wires to RWAL valve and to combination valve switch.
10. Fill and bleed brake system. See: Brake Bleeding/Service and Repair
