RAM 3500 Truck 4WD V10-8.0L VIN W (1997)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
REMOVAL
WARNING: Hot, pressurized coolant can cause injury by scalding. Cooling system must be partially drained before removing the coolant
temperature sensor.
1. Partially drain cooling system.
Fig. 8 Engine Coolant Temperature Sensor - Typical
2. Disconnect electrical connector from sensor.
3. Remove sensor from intake manifold.
INSTALLATION
1. Install sensor.
2. Tighten to 11 N.m (8 ft. lbs.) torque.
3. Connect electrical connector to sensor.
4. Replace any lost engine coolant.
