RAM 3500 Truck 4WD V10-8.0L VIN W (1997)
4. Line up key with keyway in sprocket, press on crankshaft timing sprocket, use tools C-3688, C-3718 and MB990799, or equivalents, to seat
sprocket against crankshaft shoulder.
5. Align timing mark on crankshaft sprocket with center line of crankshaft and camshaft.
6. Put chain on camshaft sprocket.
7. Take chain and camshaft sprocket and align mark with centerline of crankshaft and camshaft install camshaft sprocket and chain to camshaft.
8. Install the camshaft bolt. Tighten bolt to 75 Nm (55 ft. lbs.) torque.
9. Install the timing chain cover.
10. Install the crankshaft pulley/damper use too C-3688, or equivalent.
11. Prime oil pump by squirt oil in the oil filter mounting hole and filling the J-trap of the front timing cover. When oil is running out, install oil filter
that has been filled with oil.
12. Each tappet reused must be installed in the same position from which it was removed. When camshaft is replaced, all of the tappets must be
replaced.
13. Install tappets and push rods in their original location.
14. Install the rocker arms.
15. The cylinder head cover gasket can be used again. Install the gasket onto the head rail. For the left side the number tab is at the front of engine
with the number up. For the-right side the number tab is at the rear of engine with the number up.
CAUTION: The cylinder head cover fasteners have a special plating. DO NOT use alternative fasteners.