RAM 3500 Truck 4WD V10-8.0L VIN W (1997)
Intake Manifold: Service and Repair
REMOVAL
1. Disconnect the negative cable from the battery,
2. Drain the cooling system.
3. Remove the accessory drive belt.
Generator And A/C Compressor Braces
4. Remove the generator brace and generator.
5. Remove the A/C compressor brace. Remove the compressor and set aside.
Air Intake Housing
6. Remove the air cleaner cover and filter. Remove the air cleaner housing. Discard the gasket.
7. Perform the Fuel Pressure Release procedure. Disconnect the fuel lines.
8. Disconnect the accelerator linkage and if so equipped, the speed control and transmission kickdown cables.
9. Remove the coil assemblies with the ignition cables.
10. Disconnect the vacuum lines.
11. Disconnect the heater hoses and bypass hose.
12. Remove the closed crankcase ventilation and evaporation control systems.