RAM 3500 Truck 4WD V10-8.0L VIN W (1997)
Wheel Bearing: Service and Repair
Front
Hub/Bearing w/5 Studs
REMOVAL
1. Raise and support the vehicle.
2. Remove wheel and tire assembly.
3. Remove brake caliper and rotor, refer to Brakes and Traction Control.
4. Remove ABS sensor if equipped, refer to Brakes and Traction Control.
5. Remove cotter pin and axle hub nut.
Rotor And Hub Attaching Bolts
6. Remove hub/bearing mounting bolts.
7. Remove hub/bearing, brake shield and spacer from steering knuckle.
INSTALLATION
1. apply liberal quantity of anti-seize compound to splines of front drive shaft.
2. Insert two rear-most, top and bottom rotor hub side of knuckle so they extend out front face as shown.
Hub Spacer Positioning
