RAM 3500 Truck 4WD V10-8.0L VIN W (1997)
7.
Then, insert the probe of special tool 6934 (Figure 3) into the back of the insulator cavity.
8.
Grasp the wire and tool 6934 and slowly remove the wire and terminal from the insulator (Figure 4). Then, remove the strain relief and wire seal
(Figure 1).
9.
Inspect the initial and final locks of the insulator (Figure 1) for damage. Replace the insulator if there are any signs of damage.
10.
Inspect all wire terminals for corrosion. If corrosion is evident, replace the terminal ends and the insulator.
11.
To verify how secure the cavity of the terminal fits onto the PCM pins, insert and remove the wire end terminal onto the mating pin of the PGM.
Then, rotate the terminal 90°, 180°, and 270° while inserting and removing the terminal from the pin. If any connection is loose, replace the wire
end terminal.
12.
Inspect and replace the PCM connector cover or connector plug if the locking tabs are damaged.
Perform the following Repair Procedure if damage or wear is identified in any component of the insulator or terminals (including corrosion on the
terminal).
