RAM 3500 Truck 4WD V10-8.0L VIN W (1997)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Location
REMOVAL
1. Disconnect negative battery cable.
2. Raise and support vehicle.
3. Disconnect sensor electrical connector.
4. Remove sensor mounting bolt.
5. Carefully remove sensor in a rocking motion with two small screwdrivers.
6. Remove sensor from vehicle.
7. Inspect sensor O-ring.
Crankshaft Position Sensor
Crankshaft Position Sensor Installation
INSTALLATION
1. Apply a small amount of clean motor oil to sensor o-ring.
2. Install the sensor into the cylinder block with a slight rocking motion. Do not twist sensor into position as damage to sensor may result.
