RAM 3500 Truck 4WD V10-8.0L VIN W (1997)
Fig 48 Switch Mounting Screws
2. Remove 3 ignition switch mounting screws. Use tamper proof torx bit (Snap-On SDMTR10 or equivalent) to remove screws.
3. Gently pull switch away from column. Release connector locks on 7-terminal wiring connector at ignition switch and remove connector.
4. Release connector lock on 4-terminal halo lamp wiring connector and remove connector.
IGNITION SWITCH AND KEY CYLINDER INSTALLATION
If installing ignition key lock cylinder only, proceed to following steps 2, 3 and 4. Also refer to following steps 12 through 18. If installing both switch
and key cylinder, refer to steps 1 through 18.
Fig 50 Flag In RUN Position
