RAM 3500 Truck 4WD V10-8.0L VIN W (1997)
14.
Install two 2-way brake line clips, p/n 52008940, between the 3-way brake line bracket and clip the hydraulic control unit. One clip should be
spaced approximately three inches away from the hydraulic control unit and the other approximately three inches forward of the 3-way brake line
bracket and clip.
15.
Attach the 3-way brake tube support clip, p/n 52009437, to the brake tubes located on the top of the left frame rail.
16.
Attach the 3-way brake line clip, p/n 52009163, to the brake tubes approximately 7 - 8 inches reward of the 3-way brake line bracket and clip.
17.
Tighten and torque all brake tube fittings to 20 Nm (178 in. lbs.).
18.
Remove the brake pedal prop.
19.
Bleed the brakes using the procedures stated in the 1997 Ram Truck Service Manual (Publication No. 81-370-7108), pages 5-15 and 5-16.
20.
Fill the master cylinder with Mopar Dot 3 Brake Fluid, p/n 04318080.
21.
Verify that there is proper clearance between the intermediate shaft and the brake lines by turning the steering wheel completely to the left then to
the right. Visually inspect the intermediate shaft while turning the steering wheel to ensure that the intermediate shaft does not contact the brake
lines at any time.
