RAM 3500 Truck 4WD V10-8.0L VIN W (1997)
14.
Using a small tubing cutter, cut the existing pressure line at approximately 120 mm (5 in.) from the transmission housing end. Repeat the
procedure for the existing return line.
CAUTION:
AFTER CUTTING THE PRESSURE LINE, MARK IT WITH A PIECE OF TAPE FOR IDENTIFICATION.
15.
Identify the proper return line ("R" line) by using the marked labels attached to the tubes.
16.
Connect the "R" line to the bypass assembly block and the rearward return port of the transmission housing. Tighten the compression fitting finger
tight, and then wrench tighten it an additional 1/2 turn. Tighten the inverted flare nut to 6.78 Nm (60 in. lbs.).
17.
Select the appropriate "RR" and "P" tubes for the application. Mixing or matching may be required to provide the best routing for your
