RAM 3500 Truck 4WD V10-8.0L VIN W HDC (1999)
Rotor And Hub/Bearing
9. Press out the wheel studs/hub extension studs and separate the rotor from the hub.
INSTALLATION
1. Position rotor on the hub/bearing.
Rotor, Hub/Bearing And Stud
2. Press wheel studs/hub extension studs through the back side of the rotor and through the hub/bearing flange.
3. Apply liberal quantity of anti-seize compound to splines of front drive shaft.
4. Insert two rearmost, top and bottom rotor hub bolts in steering knuckle. Insert bolts through back side of knuckle so they extend out front face as
shown.
