RAM 3500 Truck 4WD V10-8.0L VIN W HDC (1999)
Wheel Hub: Service and Repair
Hub/Bearing w/8 Studs
REMOVAL
1. Raise and support vehicle.
2. Remove wheel and tire assembly.
Hub Extension
3. Remove hub extension mounting nuts and remove the extension from the rotor if equipped.
4. Remove brake caliper.
5. Remove the cotter pin and hub nut from the axle shaft.
6. Disconnect the ABS wheel speed sensor wire from under the hood. Remove sensor wire from the frame and steering knuckle if equipped.
Rotor And Hub Attaching Bolts
7. Remove hub/bearing mounting bolts from inboard side of steering knuckle.