RAM 3500 Truck 4WD V8-360 5.9L VIN 5 Magnum (1998)
Rotor And Hub/Bearing
9. Press out the wheel studs/hub extension studs and separate the rotor from the hub.
INSTALLATION
1. Position rotor on the hub/bearing.
Rotor, Hub/Bearing And Stud
2. Press wheel studs/hub extension studs through the back side of the rotor and through the hub/bearing Range.
3. Apply liberal quantity of anti-seize compound to splines of front drive shaft.
4. Insert two rear-most, top and bottom rotor hub bolts in steering knuckle. Insert bolts through back side of knuckle so they extend out. front face as
shown.