RAM 3500 Truck 4WD V8-360 5.9L VIN 5 Magnum (1998)
Servo Cable Clip Remove/Install - Typical
6. Position servo assembly to gain access to 2 servo mounting nuts.
7. Remove 2 mounting nuts holding servo cable sleeve to bracket.
8. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip and remove clip. Note: The servo
mounting bracket displayed in is a typical bracket and may/may not be applicable to this model vehicle.
INSTALLATION
1. Position servo to mounting bracket.
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
3. Insert servo studs through holes in servo mounting bracket.
4. Insert servo studs through holes in servo cable sleeve.
5. Install servo mounting nuts and tighten to 8.5 N.m (75 in. lbs.) torque.
6. Connect vacuum line to servo.
7. Connect electrical connector to servo terminals.
8. Install three bolts retaining servo/servo mounting bracket to battery tray.
9. Connect servo cable to throttle body. Refer to Servo Cable Replacement.
10. Connect negative battery cable to battery.
11. Before starting engine, operate accelerator pedal to check for any binding.
