RAM 3500 Truck 4WD V8-360 5.9L VIN 5 Magnum (1998)
Heater - A/C Control Temperature Control Cable Remove/Install
9. Release the temperature control cable housing flag retainer latch in the receptacle on the back of the heater-A/C control and disengage the flag
retainer from the receptacle.
10. Rotate the heater-A/C control assembly as needed to disengage the cable end from the hole on the end of the temperature control lever.
11. Remove the heater-A/C control from the instrument panel.
INSTALLATION
1. Connect the temperature control cable core end to the temperature control lever on the back of the heater-A/C control.
2. Connect the temperature control cable housing flag retainer to the receptacle on the back of the heater-A/C control.
3. Plug the wire harness connectors.into the receptacles.on the back of the heater-A/C control.
4. Route the heater-A/C vacuum harness through the hole in the reinforcement below the heater-A/C control opening of the instrument panel.
5. Position the heater-A/C control in the instrument panel and secure it with four screws.Tighten the screws to 2.2 N.m (20 in.lbs.).
6. Reinstall the cluster bezel to the instrument panel. Refer to Instrument Panel, Gauges and Warning Indicators/Instrument Panel/Cluster Bezel
Replacement for the procedures.
7. Reach under the instrument panel to reinstall the heater-A/C control vacuum harness retainer to the side of the center distribution duct.
