RAM 3500 Truck 4WD V8-5.7L VIN D (2003)
Power Distribution Module: Service and Repair
Front Control Module
REMOVAL
1. Disconnect the positive and negative battery cables from the battery.
2. Partially remove the integrated power module from the engine compartment.
3. Remove the front control module retaining screws.
4. Using both hands, pull the front control module straight from the integrated power module assembly to disconnect the 49-way electrical connector
and remove the front control module from the vehicle.
INSTALLATION
1. Install the front control module on the integrated power module assembly by pushing the 49-way electrical connector straight in.
2. Install the front control module retaining screws. Torque the screws to 7 in. lbs.
3. Install the integrated power module.
4. Connect the positive and negative battery cables.