RAM 3500 Truck 4WD V8-5.7L VIN D (2003)
6. Remove axle shaft (Fig. 16) from steering knuckle and axle housing.
DISASSEMBLY
Single cardan U-joint components are not serviceable. If defective they must be replaced as a unit.
CAUTION: Clamp only the narrow forged portion of the yoke in the vise. To avoid distorting the yoke, do not over tighten the vise jaws.
1. Remove the bearing cap retaining snap rings (Fig. 17).
NOTE: Saturate the bearing caps with penetrating oil prior to removal.
2. Locate a socket with an inside diameter that is larger than the bearing cap. Place the socket (receiver) against the yoke and around the perimeter of
the bearing cap to be removed.
3. Locate a socket with an outside diameter that is smaller than the bearing cap. Place the socket (driver) against the opposite bearing cap.
