RAM 3500 Truck 4WD V8-5.7L VIN D (2003)
Seals and Gaskets: Service and Repair
Adapter Housing Seal
ADAPTER HOUSING SEAL
REMOVAL
1. Raise and support vehicle.
2. Mark the propeller shafts and yokes for installation reference and remove the shafts.
3. Support transmission with a transmission jack.
4. Remove engine rear support.
5. Remove transfer case.
6. Remove adapter housing seal with a pry tool or slide hammer mounted screw (Fig. 131).
INSTALLATION
1. Install adapter housing seal with Installer C-3860-A and Handle C-4171.
2. Install transfer case.
3. Install propeller shafts with reference marks aligned.
4. Fill transfer case and transmission to proper level.
5. Remove support and lower vehicle.
